![]() When you remove the stem assembly, that should be the first part that you assess. I don't know if I try to find an OEM cartridge assembly or if the non-OEM one (Danco) is fine and there is a different problem. The most common reason for a leaky faucet is a washer you need to replace. After installed the bathtub spout seal disc, the water will be blocked. ![]() I'm not really sure where the leak might be coming from. The leakage disc seal is made of high quality PE material and can be used for decades. So I bought the non-OEM cartridge yesterday and installed it and as I mentioned in the previous post, the tub spout leak went from constant to intermittent. I did end up getting everything off so I installed the replacement cartridge assembly, escutcheon, handle, etc and this is when the tub spout started to drip all day. After years of regular use, the bathtub faucet handles may begin to leak at their base, usually where they meet the wall. Step 4: Use vinegar and a soft brush to clean any debris off the copper piping on the bathroom wall. Step 3: Bring your new spout home and read the instructions. Step 2: Take it to the hardware store and buy a suitable replacement. I don't know if there was corrosion in the internal components that prevented me from removing the pieces but it was a nightmare to get off. Step 1: Shut off your water supply and remove your spout from the wall. Depending on your setup it should be pretty much the same. For whatever reason, nothing was coming off easy. How To Fix A Leaking Bathtub Faucet Quick And Easy Taking things apart. Then this past Friday, I started to replace the lever handle, escutcheon, and trim but ran into some issues. If your water pressure is too high, it can cause the seals on your faucet to wear out and eventually leak. So last week, I replaced the tub spout and had no leaks. I contacted Delta and they sent me a replacement kit. Why the Leak There is a valve in your tubs faucet that diverts water from the tub to the shower head when the switch or lever is pulled to turn on. The spout was discolored/corroded and the single handle lever was corroded along with the trim for it. The tub & shower kit in our master bathroom had corrosion on the fixtures.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |